







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wellborn Driveway & Pavers: The Long Beach Owner’s Guide
If you own a Wellborn paver driveway in Long Beach and a section has settled, cracked, or separated, the repair usually means replacing affected pavers plus re-compacting the base beneath them. Our crew stocks Wellborn-compatible pavers and edge restraints on the truck, and a typical paver driveway repair in Long Beach runs between $1,200 and $6,500 depending on how much of the base has shifted. Most Long Beach owners notice the problem first as a low spot that holds water after rain, or a paver that wobbles when you step on it near the garage apron.

The most common failure we see in Long Beach is not the Wellborn paver itself. It’s the sand and gravel base underneath, which shifts in our clay-heavy coastal soil after a few wet winters. We’re an independent contractor in Long Beach, not a Wellborn company, but we work with their pavers often enough to know exactly which edge restraints and joint sands hold up along the coast. Call (562) 512-7086 and we’ll send someone out to look at the low spot, measure the affected area, and give you a written price before any work starts.
Which Wellborn Models This Applies To

Wellborn’s driveway pavers fall into three main lines we see across Long Beach: their standard 60mm interlocking paver, their 80mm heavy-duty paver rated for vehicle traffic, and their permeable paver designed for drainage in areas near the water table. The 60mm paver works fine for walkways and patios, but if it’s been used on a driveway that sees a pickup truck or an SUV every day, we see corner cracking within about five years. The 80mm paver holds up correctly on driveways along Second Street and through Belmont Shore, where the parking situation means every inch of driveway gets used.
Here’s the compatibility gotcha most Long Beach owners don’t know: Wellborn changed their edge restraint channel depth about eight years ago, from a 2-inch to a 3-inch profile. If your driveway was installed before that change and you try to set a newer edge restraint into the existing concrete collar, it sits too high and catches tires. We check this measurement before ordering anything. Our team typically installs genuine Wellborn pavers when the driveway is visible from the street and the color match matters, but we’ll also recommend a quality aftermarket equivalent from Belgard or Calstone when the Wellborn color has been discontinued and the patio is in the back where a slight shade difference won’t show. The written price we give you reflects which paver we’re actually using, so there’s no surprise line item at the end.
Styles & brands we work with






Signs Your Wellborn Driveway & Pavers Is Failing
- Water pooling in one spot after a light rain. This tells us the base has settled under that section. The pavers themselves are usually fine; the ground beneath them has washed out.
- A paver that wobbles or rocks when you step on it. This means the joint sand has washed away or was never vibrated into place properly. Left alone, the wobbling paver wears down its neighbors’ edges.
- Cracks running diagonally across several pavers in a line. This pattern usually points to a vehicle load heavier than the paver was rated for, or a tree root flexing under the driveway’s edge.
- Weeds sprouting through the joints in one concentrated area. Weeds grow through missing joint sand, and the missing sand tells us water has been moving through the base, taking material with it.
- Edges of the driveway spreading outward where it meets the lawn or curb. The edge restraint has failed, and once the perimeter moves, the interlock weakens across the whole section.
Graham Stein has seen all five of these on Wellborn driveways across Long Beach, from Naples Island up through Los Altos. The edge-spread issue shows up most often on driveways that slope gently toward the street, because the downhill edge catches the most lateral pressure from parked cars.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For a Wellborn paver driveway repair in Long Beach, here’s what we quote at:

- Isolated low-spot repair (under 50 square feet): $1,200 – $3,500
- Mid-size section replacement with base re-compaction: $3,500 – $6,500
- Full driveway re-set on existing pavers: $7,000 – $18,000
- New paver driveway installation (Wellborn or equivalent): $7,000 – $18,000
The range comes down to three things: how many square feet we’re lifting, whether the gravel base needs to be dug out and replaced or just re-compacted, and whether we’re working around an existing concrete collar or cutting a new one. Every quote includes the pavers, new joint sand, edge restraints where needed, haul-away of the old base material, and a written price before we start. The 365-Day Done Right Promise covers every repair we do in Long Beach: if something settles again in the first year, we come back and make it right.
DIY or Call Us?
You can safely check a few things before calling anyone. Walk the driveway after the next real rain and mark the low spots with chalk. Check whether the edge restraint is visible anywhere, especially where the lawn meets the paver line. Take a photo of the paver’s underside if you have a loose one; the Wellborn stamp is usually there, and that tells us which generation you have. What we don’t recommend is lifting pavers and adding sand yourself. The base underneath compacts differently than the surface looks, and if you add the wrong joint material, water gets trapped and makes the original settlement worse within a season. We’ve followed behind enough YouTube-inspired driveway fixes in Long Beach to know they usually cost more to correct than the original repair would have. If you want a real number, call (562) 512-7086 and ask for a free estimate. The price I write down on day one is the price on the invoice when we’re done.
FAQs

You can expect 20 to 30 years from an 80mm Wellborn paver on a properly compacted base in Long Beach, though the joint sand typically needs refreshing every 4 to 6 years due to our coastal rain patterns and occasional Santa Ana winds. Call (562) 512-7086 and we’ll look at your base and tell you honestly how much life is left in it.
Yes, individual pavers can be swapped out, though we’ll always check the base under the cracked paver first; if the base has failed, replacing the paver alone will crack again within a year or two. Call (562) 512-7086 for a quick inspection and a written price either way.
A small low-spot repair takes one day with our two-person crew, and a mid-size section replacement typically takes two to three days including base work and final compaction. For a full re-set, plan on four to six working days, and we’ll tell you the timeline in writing before we begin.
We keep a standard mix of Wellborn 60mm and 80mm pavers in common Long Beach colors on the truck, along with edge restraints and polymeric sand, so smaller repairs don’t wait on a supplier order. If your color or generation is out of stock, we’ll source it or show you the closest match in writing before you commit to anything.
Written by Graham Stein, Owner, Elmstead Remodeling Long Beach at Elmstead Remodeling Long Beach, serving Long Beach and nearby areas.


